How to Fix Vape Pen Wires

Wire problems are a common reason why disposable vape sometimes don’t work properly. Try making a few minor corrections before throwing away your vape. Try some of our tips to get your vape working again.

First, empty the heating chamber of all trash. If the coil appears clean, move it about inside the chamber using a paperclip. Soldering or replacing the broken electrical cable are the only available repair options.

Tidying up the cables:

  Take off the heating chamber of the vape pen. The mouthpiece, located at the top of the pen. To take it out, turn it anticlockwise. The coil-filled heating chamber will be visible at that point. Maintaining the wire coil in place, pull it off in the same manner.The pen needs to warm up first to get rid of any residue. However, turn off the vape before disassembling it, and stay away from it if it’s too hot.

Make sure to thoroughly clean the heating chamber:

Seal the heating chamber and place it inside a garbage bag. Tap it against a solid surface, such as your palm, to remove any loose particles. carefully clean the inner part of your vape with a cleaning solution.

Many disposable vapes packaging includes small brushes for cleaning your vape like Lost Mary 15000 Puffs and the Al Fakher Crown Bar vape.

To remove wax and oil from the coil, wipe it with isopropyl alcohol:

Purchase a bottle of isopropyl alcohol from a drugstore or general shop. Instead of soaking a cotton swab, wet it. The isopropyl alcohol does not have to seep into the remaining pen substance. If the coil and chamber seem discoloured or blocked with debris, use the cotton swab to clean them.

• Be delicate when working with the coil. That wire is the most susceptible part of the pen, and it’s usually the cause of a pen breaking.
• Be mindful to not use water for cleaning inside of the heating chamber.because water can cause short circuits.use water for cleaning external part of your disposable vape.

Screw the pen back together to test it.

Make sure to clean and dry your vape properly before screwing it back.Before using the pen, put the heating chamber back on. It should continue to release smoke and shine normally.If it doesn’t work, the pen may need extra cleaning or the wire may be misaligned.

Method 2

Adjusting the Coil

Take apart the pen to look inside the heating chamber.

• Take out the pen’s mouthpiece once more. Once the wire coil inside the heating chamber is visible, keep removing pieces. It will be situated exactly above the lowest point where the battery is located.
• Check to see if the pen is cool to the touch. The pen won’t heat up at all if the coil needs to be changed. If you sense any heat emanating from the coil, stay away from it.

Check that the screws are in place:

 The coil is secured into the heating chamber by two screws. The first screw, which is at the bottom of the coil, is used to position the coil over the battery. The other screw, which is at the higher end, fastens the coil to the wall of the heating chamber.

If the screws aren’t in place, your coil is most likely out of position. Take it to a vape pen store to acquire new screws.

Conclusion:

Fixing your vape pen’s wiring might seem difficult but if you use the right method and equipment it is quite easy.by following our tips you might get your vape working again perfectly.but remember to always prioritise safety and avoid any risky events.If you face any issues that are beyond your scope of expertise, don’t be afraid to seek our professional help.

Get your favourite vape such as  lost mary 15000 puffs or al fakher crown bar from our online vape shop.Cheers to your vaping!